CE Smith Front/Rear Hanger for Double-Eye Springs - 1-7/16" Tall - 9/16" Bolt Hole

Video Transcript for Review of CE Smith Trailer Leaf Spring Suspension - Double-Eye Spring Hanger Bracket - CES83FR

Hi there, I'm Michael with etrailer.com. Today, we're gonna take a quick look at this CE Smith Double-Eye Spring Hanger Bracket. This is gonna weld onto your trailer frame and provide the attachment point for your leaf springs. This can be configured to work as either a front or a rear hanger on a tandem or triple axle application, or if you're gonna use it on a single axle trailer, it's only gonna be able to be used as a front hanger. So if you are needing to replace or add a double-eye spring hanger bracket for your trailer, this is gonna be a great way to go for you. Give you a few dimensions here, make sure it's gonna fit where you want it to.

You can see this does have an overall depth of about three inches. Our height, we're looking at approximately two inches tall. I can get the angle right for you there, so you can see it is two inches tall. Our inner width, we're sitting right at 1 7/8 of an inch, just shy of two inches wide, so this is gonna fit your 1 3/4 inch wide double-eye springs. The height from the top of our bracket down to the center of our bolt hole there, we're gonna be sitting right about just shy of 1 1/2 inches, call it 1 7/16 of an inch.

This is a 9/16 inch diameter hole there, so it is going to work with your 9/16 inch diameter bolts. And this is made here in the USA, so you can trust it is gonna be excellent quality for you, ready to get welded on and support that spring. So that completes our look for today. Again, I'm Michael with etrailer.com. Thanks for watching.

.